ICP DAS USA PISO-DNS100-D/T User Manual page 67

ГК Атлант Инжиниринг – официальный представитель в РФ и СНГ
+7(495)109-02-08 sales@bbrc.ru www.bbrc.ru
Step 1 : Select Board ID
The DIP-Switch on the board means the ID of this board. The users
should make sure that every board's ID in your PC is unique. The drop-down
list would show the board's ID which the users have selected. If you have more
than one PISO-DNS100(U) boards, please select the correct board ID which
you want to use.
Step 2 : ActiveBoard
Before performing other buttons, the "ActiveBoard" button should be
clicked firstly. After clicking the button, the return message would be "OK". It is
shown as Figure 6.4.1. Otherwise, please check the windows driver has been
installed successfully.
Step 3 : Set Baud Rate
The default baud rate is 125Kbps. If the users want to change the value,
you can select the correct value from the drop-down list. After changing the
baud rate, the uses should reset the firmware in PISO-DNS100(U) by pushing
the "ActiveBoard" button again. Wait for 1 or 2 seconds then go to the next
step.
PISO-DNS100(U) DeviceNet Slave API functions User's Manual (Ver: 1.1)
Figure 6.4.1 "Active Board" OK
2010/01/07 67