Page 1
CA-4037W Cable x1 CA-4002 D-Sub Connector x2 Appearance 1. CON1: DIO channel 0-7. 2. JP1-JP8: AC Filter Jumpers (CON1) 3. SW1: Card ID Setting. 4. PCI Bus: for PISO-P16R16U PCI Express: for PEX-P8R8i/P16R16i 1 2 3 4 ...
Page 2
CD: \NAPDOS\PCI\UniDAQ\DLL\Driver http://ftp.icpdas.com/pub/cd/iocard/pci/napdos/pci/unidaq/dll/driver/ The PISO-DIO series classic driver supports Windows 98/NT/2K and 32-bit XP/ 2003/7/8/10. Recommended to install this driver for have been used PISO-P16R16U series boards of regular user, please refer to : http://ftp.icpdas.com/pub/cd/iocard/pci/napdos/pci/piso-dio/manual/quickstart/classic/ ...
Page 3
Shut down and power off your computer. Remove the cover from the computer. Select an unused PCI/PCI Express slot. Carefully insert your I/O card into the PCI/PCI Express slot. Replace the PC cover. Power on the computer. ...
Page 5
Use the DN-37 to connect the CON1 on board. Connect the COM(0-7) with DIA (0-7). (Pin2/5/8/21/24/26/28/11 connects to Pin12/13/14/15/16/17/18/19). Power Supply (+24 V) connects to NO(0-7) (Pin1/4/7/20/23/25/27/10). Power Supply GND connects to DIB(0-7) (Pin30/31/32/33/34/35/36/37). PISO-P16R16U PEX-P8R8i/P16R16i +24V CON1 External: DP-665 Cable: CA-3710 DN-37 I/O Wiring...
Page 6
“ICPDAS” folder. Point to “UniDAQ Development Kits”and then click the “UniDAQ Utility” to execute the UniDAQ Utility Program. Confirm that PISO-P16R16U Series card has been successfully installed in the host system. Note that the device numbers start from 0. ...
Page 7
Check the results of the Digital Input/Output functions test. 1. Click the “Digital Output” tab. 2. Select “Port0” from the “Port Number” drop-down menu. Check the checkboxes for channels 0, 2, 4 and 6. 4. Click the “Digital Input” tab. 5.
Need help?
Do you have a question about the PISO-P16R16U and is the answer not in the manual?
Questions and answers