ICP DAS USA PISO-DNS100-D/T User Manual page 62

ГК Атлант Инжиниринг – официальный представитель в РФ и СНГ
+7(495)109-02-08 sales@bbrc.ru www.bbrc.ru
The DIP-Switch on the board means the ID of this board. The users
should make sure that every board's ID in your PC is unique. The drop-down
list would show the board's ID which the users have selected. If you have more
than one PISO-DNS100(U) boards, please select the correct board ID which
you want to use.
Step 2 : ActiveBoard
Before performing other buttons, the "ActiveBoard" button should be
clicked firstly. After clicking the button, the return message would be "OK". It is
shown as Figure 6.3.2. Otherwise, please check the windows driver has been
installed successfully.
Step 3 : Clear All Config
To avoid unknown configuration in the PISO-DNS100(U), the users can
push this button to clear all configuration in the board. Note that the baud rate
of the CAN bus would be set to 125K bps.
Step 4 : Set Baud Rate
PISO-DNS100(U) DeviceNet Slave API functions User's Manual (Ver: 1.1)
Figure 6.3.2 "ActiveBoard" OK
2010/01/07 62