Adding The Rear Wheel Ballast; Checking The Angle Indicator - Toro Groundsmaster 3500-G Operator's Manual

2
Adding the Rear Wheel
Ballast
No Parts Required
Procedure
Add 22.6 kg (50 lb) of calcium-chloride ballast to the
rear wheel.
Important:
If a puncture occurs in a tire
containing calcium chloride, remove the machine
from the turf as quickly as possible. Immediately
soak the affected area with water to prevent
possible damage to the turf.
3
Checking the Angle
Indicator
Parts needed for this procedure:
1 Inclinometer
Procedure
1. Park the machine on a flat, level surface.
2. Verify that the machine is level by placing
a handheld inclinometer (supplied with the
machine) on the frame cross rail, by the fuel
tank (Figure 5).
Note:
The inclinometer should read at 0° when
viewed from the operating position.
1. Angle indicator
3. If the inclinometer does not read 0°, move the
machine to a different location to obtain a 0°
reading.
Note:
The angle indicator, mounted on the
machine, should now read 0° also.
4. If the angle indicator does not read 0°, loosen the
2 screws and nuts securing the angle indicator
to the mounting bracket, adjust the indicator to
obtain a 0° reading, and tighten the bolts.
11
Figure 5
g031569