Table of Contents
Advertisement
Recall Timer Duration (#107)
Description
This system option lets you change the length of the timed signal, or switchhook
flash, generated by the system Recall feature (as well as by the Recall function
used in Auto Dial or System Speed Dial numbers). Recall sends this timed
signal over the phone line to the local telephone company or PBX to which the
system is connected. Typically you use the Recall feature to access a PBX,
Centrex, or local phone company custom calling feature (such as Call Waiting).
You should only change the factory setting under two conditions:
If using the system Recall feature has no effect, lengthen the time.
If your system is connected to a PBX or Centrex system and using the
system Recall feature drops calls, shorten the time. (The setting typically
used for PBX systems is "18" (or 450 msec.); for Centrex systems, it is "32"
(or 800 msec.).)
Valid Entries
01 through 80 (25 to 2000 msec. in 25 msec. increments)
18 (450 msec.)
Programming
To change the duration of the timed signal, follow these steps from extension 10:
Press [
1.
The phone beeps once, and the light next to [
Press left [
2.
The light next to left [
Press [
3.
#
4.
Enter the setting number you want. For example, press [
800 msec.
If you make a mistake, begin again at Step 3.
5.
6.
When you are finished, press [
press [
Feature
] [
] [
].
Feature
0
0
] twice.
Intercom
] is green steady.
Intercom
] [
] [
] [
].
1
0
7
] and a three-digit code for another option or
#
] [
] [
].
0
0
] is green flutter.
Spkr
] [
] to change to
3
2
Recall Timer Duration (#107)
5-31
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the PARTNER and is the answer not in the manual?
Questions and answers