AT&T PARTNER Installation And Use Manual page 105

5
A) To connect the AC power cord: on a 2-module
system, connect it to the module connector;
otherwise, connect it to the 206 system
module. Press firmly until it clicks as it locks
into place.
B) To power up the system, plug the other end of
the power cord into a properly grounded
three-prong wall outlet not controlled by a
switch.
On a PARTNER 220V system, move the on/off
switch to the "on" position ("l").
6
Check the green LEDs on the fronts of the module(s).
If the lights are lit, you can go on to the next section.
If not, see "All Phones Dead: No Dial Tone or Lights" in
Chapter 6, "Troubleshooting."
C-10 Installation