4. Install the blade server cover (see "Installing the blade server cover" on page
5. Install the blade server into the BladeCenter unit (see "Installing the blade
6. Turn on the blade server and run the Configuration/Setup Utility program. Set
Removing the power jumper
To remove the power jumper from a blade server, complete the following steps.
Note: A power jumper is not installed when a Memory and I/O Expansion Blade is
installed.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Remove the blade server cover (see "Removing the blade server cover" on
4. Locate the power connector J164 on the system board.
5. Lift and remove the power jumper from the power connector.
81).
server in a BladeCenter unit" on page 78).
configuration parameters as needed (see "Using the Configuration/Setup Utility
program" on page 107 for information).
Power jumper
on page 75
the blade server from a BladeCenter unit" on page 77 for instructions).
page 80 for instructions).
Chapter 4. Removing and replacing blade server components
99