Removing a high-speed expansion card
To remove a high-speed expansion card, complete the following steps.
1. Read the safety information that begins on page "Safety" on page vii and
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Remove the blade server cover (see "Removing the blade server cover" on
4. Rotate the extraction lever upward to disengage the blade-expansion connector.
5. Pivot the narrow end of the card away from the blade expansion connector;
6. If you are instructed to return the expansion card, follow all packaging
Installing a high-speed expansion card
To install a high-speed expansion card, complete the following steps.
1. Locate the blade expansion connector.
2. Touch the static-protective package that contains the expansion card to any
3. Orient the expansion card and slide the slots at the back end of the card onto
96
BladeCenter HS21 Types 1885 and 8853: Problem Determination and Service Guide
High-speed
expansion card
Expansion
card
standoff
"Installation guidelines" on page 75.
the blade server from a BladeCenter unit" on page 77).
page 80 for instructions).
then, slide the slots at the back end of the card out of the expansion-card
standoffs and lift the card out of the blade server.
instructions, and use any packaging materials for shipping that are supplied to
you.
High-speed
expansion card
Expansion
card
standoff
unpainted metal surface on the BladeCenter unit or any unpainted metal surface
on any other grounded rack component; then, remove the expansion card from
the package.
the pins on the expansion card standoff; then, gently pivot the card into the
blade expansion connector.
Extraction lever
Blade
expansion
connector
cover
Blade
expansion
connector