Installing A Sas Hard Disk Drive - IBM BladeCenter HS21 Series Problem Determination And Service Manual

Installing a SAS hard disk drive

To install a SAS hard disk drive, complete the following steps.
Hard disk drive
release lever
1. Identify the location (SAS ID 0 or SAS ID 1) in which the hard disk drive will be
2. Touch the static-protective package that contains the hard disk drive to any
3. Place the drive into the hard disk drive tray and push it toward the rear of the
4. If a Memory and I/O Expansion Blade is installed, remove it (see "Removing an
5. Install the blade server cover (see "Installing the blade server cover" on page 81
6. Install the blade server into the BladeCenter unit (see "Installing the blade
86
BladeCenter HS21 Types 1885 and 8853: Problem Determination and Service Guide
SAS ID 1
SAS ID 0
Hard disk
drive release
lever
installed.
Note: If you will be installing the SAS hard disk drive in to the SAS ID 1
location, you may need to remove a standard-form-factor expansion card tray
(see "Removing a standard-form-factor expansion card" on page 94); then,
install the SAS hard disk drive tray with the four screws you removed from the
expansion card tray.
unpainted metal surface on the BladeCenter unit or any unpainted metal surface
on any other grounded rack component; then, remove the hard disk drive from
the package.
Attention: Do not press on the top of the drive. Pressing the top might
damage the drive.
drive, into the connector until the drive moves past the lever at the front of the
tray.
expansion unit" on page 82).
for instructions).
server in a BladeCenter unit" on page 78 for instructions).