Installing A Small-Form-Factor Expansion Card - IBM BladeCenter HS21 Series Problem Determination And Service Manual

Installing a small-form-factor expansion card

To install a small-form-factor expansion card, complete the following steps.
1. Touch the static-protective package that contains the expansion card to any
2. Orient the expansion card over the system board.
3. Slide the notch in the narrow end of the card into the raised hook on the
4. Install the Memory and I/O Expansion Blade, if one was removed from the blade
5. Install the blade server cover (see "Installing the blade server cover" on page
6. Install the blade server into the BladeCenter unit (see "Installing the blade
Small-form-factor
expansion
card
unpainted metal surface on the BladeCenter unit or any unpainted metal surface
on any other grounded rack component; then, remove the expansion card from
the package.
expansion card bracket; then, gently pivot the card into the expansion card
connector.
Note: For device-driver and configuration information to complete the
installation of the expansion card, see the documentation that comes with the
expansion card.
server when the expansion card was removed (see "Installing an expansion
unit" on page 83).
81).
server in a BladeCenter unit" on page 78).
Chapter 4. Removing and replacing blade server components
93