Installation Instructions - Assa Abloy SARGENT Profile Series Installation Instructions Manual

Profile Series v.s2 WiFi Cylindrical Lock

Installation Instructions

8
Step #1 – Door Preparation
A. Verify Hand and Bevel of Door
Stand on outside/locked side of door when determining the door hand
LH
Left Hand
Hinges Left
Open Inward
B. Prepare Door
• Prior to installation, all holes must be free of burrs, debris and sharp edges.
• If doors are not properly reinforced per ANSI 115.2, commercially available reinforcements
should be installed.
• Prepare door according to appropriate template (refer to web site www.intelligentopenings.com):
Door Manufacturing template: 4632.
Through-bolt Hole
Ribbon Cable Hole
(Controller to Keypad)
Lever Handle Hole
LHRB
Left Hand
Reverse Bevel
Hinges Left
Open Outward
Fig. 1A
Inside of Door
DPS
Pre-drilled
Tap Holes
Cylindrical
Pocket and
Latch Hole
Fig. 1B Wood Door Preparation
RH
Right Hand Right Hand
Hinges Right Reverse Bevel
Open Inward Hinges Right
Open Outward
Outside of Door
RHRB
Through-bolt Hole
Ribbon Cable Hole
(Controller to Keypad)
Lever Handle Hole
Through-bolt Hole
A7785E 7