Assa Abloy SARGENT Profile Series Installation Instructions Manual page 11

Profile Series v.s2 WiFi Cylindrical Lock
Step #9 – Install Door Position Switch (DPS)
1. Prep door according to proper template:
Wood: A7980
Metal: 4632.
2. Insert DPS into the raceway on the latch edge of the door.
3. To insert DPS, push wires through raceway toward lock prep.
Note: Only use collar when installing in a metal door.
4. Push DPS firmly into place by hand.
Note: DO NOT TAP SWITCH WITH ANY TOOL.
5. To connect DPS to lock controller per diagram, refer to
the wiring in the following steps.
Step #10 Install Gasket and Outside Escutcheon
For exterior applications, use weatherseal gasket between escutcheon and outside door surface.
To apply weatherseal gasket:
1. Carefully remove the backing from the gasket (Fig. 10A).
2A. For fire rated doors: Feed ribbon cable with connector and ground wire from
outside of door through weather seal gasket and fire stop plate (Fig. 10A).
2B. For non-fire rated doors
and ground wire from outside of door through weather seal gasket (if used)
and weather conduit (not shown).
Note: Install ribbon cable with cable exiting down.
3. Apply gasket to escutcheon:
a. Starting in one place, press the adhesive side
of the gasket firmly against the escutcheon.
b. Work around the escutcheon, pressing the
sticky side of the gasket firmly against the
escutcheon edge.
c. The gasket should be aligned so that all edges
of the escutcheon are covered.
4. Place the outside escutcheon against, while
directing mounting posts through the door.
Inside of Door
:
Feed ribbon cable with connector
Fig. 9A
Keypad
Ribbon
Cable
Antenna
(iCLASS)
Only
Ground
Wire
(E1)
Cylinder spacer
Fig. 10A
Gasket
Outside of Door
A7785E 11