Assa Abloy SARGENT Profile Series Installation Instructions Manual page 13

Profile Series v.s2 WiFi Cylindrical Lock
Step #13 – Install Inside Escutcheon
1. Gently fold the excess ribbon connector
and ground wire into the top hole and
ground wire into offset middle hole, and
mortise and AX/DPS wires into bottom hole,
being careful not to pinch wires (Fig. 13A).
2. Insert (2) #8-32 x 1-1/4" screws through
inside escutcheon and thread into outside
escutcheon (Fig. 13B).
3. Straighten escutcheons and tighten
through bolts.
Step #14 – Install Outside Lever
1. Slide lever handle onto spindle until fully seated (Fig. 14A).
2. Rotate key 45 degrees clockwise (Fig. 14B).
3. Push lever until lever
catch is engaged.
4. Check to make sure latch
screws are tight (Fig. 14C).
˚
Push Pin Tool
Fig. 14B
Fig. 13A
Inside of door
Fig. 14C
Unused
Inside of Door
Fig. 14A
Latch Screws
Outside of door
A7785E
Inside Lever
13