Assa Abloy SARGENT Profile Series Installation Instructions Manual page 10

Step #7 - Install Lock
1. Feed wires into the lock body hole from outside of door (Fig.7A).
2. Slide lock body into cross-bore hole from outside (locked side)
of the door (Fig.7B).
3. Lock body must engage both the latch unit prongs and tail
piece (Fig. 7C).
IMPORTANT:
• Door must remain open during installation. Use door stop.
• Lock body must be centered in the door.
Step #8 – Secure the Lock to the Door
1A. For wood door: Feed wires up through the routed
channel (Fig. 8A).
1B. For metal door: Feed wires and connector through
inside of door (not shown).
2. Slide inside rose assembly and spacer bushing
over lock body and secure with (2) #10-32x1-1/4" through-bolts.
3. Secure latch with (2) additional #6 x 3/4" self-tapping screws.
4. Tighten latch screws securely.
10 A7785E
Profile Series v.s2 WiFi Cylindrical Lock
Inside of Door
Fig. 7B Detail
Inside of Door
Outside of Door
Cylindrical
Lock
Body
Fig. 7A
Fig. 8A
1
Wire Harness
(From Lock Body)
Fig. 7C Detail
3
Latch Screws