Assa Abloy SARGENT Profile Series Installation Instructions Manual page 12

Step #11 – Escutcheon Wire Connections
Images are shown without gasket. If gasket is necessary,
refer to Step #10.
Before the controller is attached
to the door:
1. Attach the reader assembly
ribbon cable into the back of
the controller assembly
(side that faces towards
the door when mounted
(Fig. 11A).
2. Attach the antenna to the
circuit board in the plastic
housing under the
controller assembly.
Note: The difference between
the wiring for the iCLASS
13.56 MHz reader and the
125 kHz Prox is that the
iCLASS wiring includes
an antenna wire.
3. Attach the ground wire to the
bottom of the controller
assembly (E1, Fig. 11A).
Step #12 – Lock Wiring Connections
1. Connect the cable from the cylindrical
lock to the bottom of the controller
assembly (TB1, Fig. 12A).
2. Connect the AX/DPS connector to the
2-pin harness.
12 A7785E
Profile Series v.s2 WiFi Cylindrical Lock
3
Ground
Reader
1
Cable
Antenna
2
(iCLASS)
Outside
Escutcheon
Door Position
Switch (DPS)
Wire
Inside of Door
Reader
Ribbon Cable
Ground
2
Wire
1 Lock
AX/DPS
Fig. 12A
Inside of Door
1
Reader
2
1
Ribbon
Cable
Antenna
(iCLASS)
3
2
Ground
Wire
3
Inside
Escutcheon
(Back)
Fig. 11A
Antenna
(iCLASS)
TB1
1
Unused
2
Inside
Escutcheon
(Back)