Table of Contents
Advertisement
7.5
STOP REASONS
In this menu you can see the list of the last five reasons for an inverter shutdown, and
time and date of each one.
12:00
13:43 (08/01) -> MANUAL STOP
17:30 (07/01) -> POW CONSUMPTION
17:37 (06/01) -> POW CONSUMPTION
17:22 (05/01) -> POW CONSUMPTION
13:15 (05/01) -> FREC
Shutdown reasons:
SR VDC
SR FREC
SR VAC
SR VARISTORS
SR INS. FAILURE
SR CURRENT RMS Overcurrent maintained at AC output
SR TEMPERATURE Power electronics overheating
SR CONFIG
SR MANUAL STOP Manual stoppage
SR MIN VPV
SR HW_DESCX2
SR FAULT (1)
SR FAULT (2
SR FAULT (3)
SR CURR.PEAK
SR FIRMWARE.CH Stoppage due to a firmware change
SR ADC READING AD converter reading failure (internal)
SR LOW POWER
SR DC.PROT
SR AUX.TEMP
SR AC PROT
SR AC MAG PROT Error at the AC magnetic breaker
SR CONTACTOR
SR WD RESET
SR ADC LAT
SR FATAL ERROR
SR CURR PI SAT
Pg. 30 de 40
09/01/09
STOP REASONS
High input voltage at the panels.
Incorrect grid frequency
Incorrect grid voltage
Failures in the AC surge arresters
DC isolation failure
Stoppage due to a configuration change
Low input voltage at the panels.
Hardware failure (internal)
Power electronics failure
Power electronics failure
Power electronics failure
Instantaneous overcurrent at AC output
Insufficient solar radiation
DC protection
Printed circuit overheating
AC protection
Error when closing the contactor
Soppage due to Watch Dog reset (internal).
AD converter error (internal).
Power electronics fatal error
Current PI saturation (internal).
Installation Manual
Ingecon® Sun Three-Phase Inverter
Ref.: AAS2000IKI02
Rev.:_
Dec-2009
Advertisement
Table of Contents
