Planmeca proline xc Installation Manual page 13

Screws
Lower bracket
Inserts
Clamping screws
Wall bracket
Clamping screws
Lower bracket
Installation manual
NOTE If you are installing a Pan/ceph unit you must se-
Bottom of
column
Top of column
Bottom of
column
cure the X-ray column to the floor with the lower
bracket.
To slide the lower bracket into the groove at the
rear of the column, you will have to turn the
bracket sideways slightly to get it into the slots,
and then use the bracket to mark the positions of
the fixing holes. Drill two 10mm (3/8in) fixing
holes and then secure the lower bracket to the
floor with the screws and plastic inserts.
When the unit is vertical tighten the column clamping
screws that hold the x-ray column to the wall bracket and,
if the lower bracket is used, tighten the column clamping
screws in the lower bracket.
Remove the protective styrofoam packaging and the tape
that you previously wrapped round the top of the column
to stop the wall bracket from sliding down.
Planmeca Proline XC X-ray unit 9
INSTALLING THE X-RAY