Table of Contents
Advertisement
Chapter 2: Installing the Switch
Unpacking the Switch
26
To unpack the IA series switch, perform the following procedure:
1. Remove all components from the shipping package.
Note
Store the packaging material in a safe location. You must use the
original shipping material if you need to return the unit to Allied
Telesis.
2. Place the switch on a level, secure surface.
3. Verify that the hardware components are included in your switch
package. Table 4 shows a list of the hardware components.
Table 4. Components in the Bracket Kit
One 3-pin terminal block for
DC power and ground wire
Four rubber feet
Console cable
(for the AT-IA810M model only)
4. If any item is missing or damaged, contact your Allied Telesis sales
representative for assistance.
Advertisement
Table of Contents
