Table of Contents
Advertisement
Starting a Management Session using the Web Interface
You can access the AT-IA810M switch using the Web interface as well as
the CLI. This section explains how to start a management session through
the Web interface.
Note
This section only applies to the AT-IA810M switch.
Note
To access the switch using the Web Interface, the switch must have
an IPv4 address and HTTP server is enabled on the switch. See
"Starting the Initial Management Session" on page 40.
To start a management session using Web interface, perform the following
procedure:
1. Connect the switch to your network.
2. Open Internet Explorer 7 or 8 on your management PC.
3. Enter the IP address of your switch into the Internet Explorer.
4. Enter the user name and password.
Figure 11. IA series switch Login Screen
5. Press OK.
You are logged in and the Web interface appears. See Figure 12 on
page 44.
IA Series Ehternet Switches Installation Guide
43
Advertisement
Table of Contents
