Table of Contents
Advertisement
Chapter 5: Starting a Management Session
Starting the Initial Management Session
What to
Configure First
Starting the
Initial
Management
Session
40
The AT-IA810M switch provides two management interfaces: the Web
interface and Command Line Interface (CLI); however, the initial
management session of the switch must be through the CLI.
Note
This section only applies to the AT-IA810M switch.
You must configure the following items during the initial management
session through CLI. After the settings, you can access the switch through
the Web interface in addition to the CLI.
Assign an IPv4 address to the switch
Enable the HTTP server
To start the initial management session through the CLI, perform the
following procedure:
1. Connect the RJ45 connector of the console cable that comes with the
switch to the Console port.
2. Connect the other end of the cable to an RS-232 port on a terminal or
PC with a terminal emulator program.
3. Configure the terminal or terminal emulator program as follows:
Baud rate: 9,600bps
Date bits: 8
Stop bits: 1
Parity: None
Flow Control: None
4. Power on the switch as shown in "Wiring and Powering on the Switch"
on page 30.
5. Press Enter on the terminal or terminal emulator program on the PC.
You are prompted to login.
login:
Advertisement
Table of Contents
