Figure 5-3 Am-Pcb Interfaces - Siemens SIPROCESS GA700 Operating Instructions Manual

Connecting
3
①
②
Figure 5-3
1. Connect the option module OM2.1 to the analog current interface
2. Connect the processing unit (PU) to the CAN interface
3. Make sure that power is provided to the AM-PCB
4. Connect the cable from the terminal block (TB) to the OM2.1.
Wall-mounted device
Operating Instructions, 01/2013, A5E31930403-01
CAN interface, 12-pin ribbon cable
Connector for cable from power supply unit
AM-PCB interfaces
module PCB (AM-PCB) using the existing 26-pin ribbon cable.
existing 12-pin ribbon cable.
supply cable.
Installing the analyzer modules and option module
5.2 Installation of the analyzer modules
1
2
③
Analog current interface, 26-pin ribbon cable
to option module
②
③
of the analyzer
①
on the AM-PCB using the
from the power supply unit via the
31