Siemens SIPROCESS GA700 Operating Instructions Manual page 42

Connecting
7.2 Connection to electricity supply
The mains supply line must comply with the valid regulations and conditions for the place of
installation and be provided with a protective conductor at the potential of the housing. The
cross-section of each wire has to be ≥ 1 mm
connected in the connector at the position marked.
● Ensure that a mains disconnection device is located in the direct vicinity of the device (for
● Ensure that the supply voltage present matches that which is specified on the nameplate
42
load rating, see nameplate).
of the device.
. The phased terminal conductors must be
2
Operating Instructions, 01/2013, A5E31930403-01
Wall-mounted device