Installing the analyzer modules and option module
5.2 Installation of the analyzer modules
Installing
①
②
Figure 5-2
1. Fit the analyzer module
2. Fasten the analyzer module
30
Wall-mounted device
Analyzer module
OXYMAT 7 installation
①
wall-mounted device
Tightening torques:
– Torx screws on bottom of housing: 0.8 Nm
– Torx screws on rear panel: 2.0 Nm
③
②
into the wall-mounted device
②
with eight Torx screws to the base of the housing of the
and with two Torx screws to the back wall.
Nameplate on wall-mounted device
①
.
Operating Instructions, 01/2013, A5E31930403-01
Wall-mounted device