Lan Connection; Lan For Operation Management (Mnt Port) - Fujitsu ETERNUS AF250 Design Manual

2. Connection Configuration

LAN Connection

LAN Connection
The ETERNUS AF requires a LAN connection for operation management.
In addition, information such as ETERNUS AF failures is notified to the remote support center.
Make sure to connect each controller to the LAN for operation management.
Specifications for the LAN ports of the ETERNUS AF are shown below.
Operation Mode
•
Ethernet (1000BASE-T/100BASE-TX/10BASE-T)
• Internet Protocol
IPv4 and IPv6 are supported.
■
IP Addresses for the ETERNUS AF
In order to connect to the LAN for operation management, an IP address for ETERNUS AF must be prepared in
advance.

LAN for Operation Management (MNT Port)

In an ETERNUS AF, the system administrator logs on to the ETERNUS AF via a LAN to set the RAID configuration,
manage operations, and perform maintenance.
In addition, the failures that occur in the ETERNUS AF are notified to the remote support center. The remote sup-
port uses MNT ports for a network connection by default. In this situation, the network connection for the re-
mote support is transferred via the LAN for operation management. When the network connection for the re-
mote support needs to be separated from the LAN for operation management, refer to
(RMT Port)" (page 137) and use the RMT ports to connect to the remote support center via a different network.
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Design Guide (Basic)
Copyright 2019 FUJITSU LIMITED
135
"LAN for Remote Support
P3AG-1822-09ENZ0