YASKAWA SERVOPACK Sigma 7S Series Supplementary Manual page 40

3.1 Monitoring Product Life
3.1.3 Preventative Maintenance
• Σ-7S SERVOPACKs with MECHATROLINK-II Communications References or Σ-7S SERVO-
PACKs with MECHATROLINK-III Communications References
Pn514
• Σ-7W SERVOPACKs with MECHATROLINK-III Communications References
Pn514
Pn597
3-4
Parameter

n. 0
Disabled (the above signal output is not used).
(default setting)
Output the signal from the CN1-1 or CN1-2 output ter-

n. 1
minal.
Output the signal from the CN1-23 or CN1-24 output

n. 2
terminal.
Output the signal from the CN1-25 or CN1-26 output

n. 3
terminal.
Parameter

n. 0
Disabled (the above signal output is not used).
(default setting)
Axis A: Output the signal from the CN1-23 or CN1-24
output terminal.

n. 1
Axis B: Output the signal from the CN1-25 or CN1-26
output terminal.
Axis A: Output the signal from the CN1-27 or CN1-28
output terminal.

n. 2
Axis B: Output the signal from the CN1-29 or CN1-30
output terminal.

n. 023 Allocate the signal to CN1-23.

n. 025 Allocate the signal to CN1-25.

n. 027 Allocate the signal to CN1-27.

n. 029 Allocate the signal to CN1-29.

n. 031 Allocate the signal to CN1-31.

n.0
Disabled (the above signal output is not used).
(default setting)

n.1 Output the above signal.

n.2 Invert the above signal and output it.
Description
Description
When Classifi-
Enabled cation
After
Setup
restart
When Classifi-
Enabled cation
After
Setup
restart
After
Setup
restart