YASKAWA SERVOPACK Sigma 7S Series Supplementary Manual page 44

4.1 Alarm Displays
4.1.3 Resetting Motor Type Alarms
Operating Procedure with Panel Operator
Step
1
2
3
4
5
6
Operating Procedure with Digital Operator
Use the following procedure.
Step
1
2
3
4
5
4-4
Panel Display after
Operation
To enable the change to the setting, turn the power supply to the SERVOPACK OFF and ON after
you execute the Reset Motor Type Alarm utility function.
Operation
Press the Key to display the Utility Mode
Main Menu, and then use the
Key to select Fn021.
Press the Key.
Press the Key.
Press the Key.
Turn the SERVOPACK power supply OFF and ON
again.
Keys
Press the MODE/SET Key to enter Utility Function
Mode.
MODE/SET DATA/
Press the UP Key or DOWN Key to display Fn021.
MODE/SET DATA/
Press the DATA/SHIFT Key for approximately one
second. The display shown at the left will appear.
MODE/SET DATA/
Press the MODE/SET Key to reset the motor type
alarm. donE will flash on the display and the display
MODE/SET DATA/
shown on the left will appear again.
Press the DATA/SHIFT Key for approximately one
second to return the display to Fn021.
MODE/SET DATA/
Key or
The Fn021 (Reset Motor Type Alarm) execution
display will appear.
The motor type alarm alarm will be reset.
When processing has been completed, the status
display will flash DONE for approximately one
second and then return to 1:A.070.
The display will return to the Utility Mode Main
Menu.
The parameter setting is now enabled.
Operation
Result
： F U N C T I O N
1 A . 0 7 0
：
F n 0 2 0 - O r i g e t
：
F n 0 2 1 M o t o r I n i t
：
F n 0 0 o f t R e e t
：
F n 0 8 0 P o l e D e t e c t
：
1 A . 0 7 0
M o t o r C o n n e c t
H i t o r y I n i t
t a r t : [ D A T A ]
R e t u r n : [ E T ]
：
1 A . 0 7 0
M o t o r C o n n e c t
H i t o r y I n i t
t a r t : [ D A T A ]
R e t u r n : [ E T ]
1 : A . 0 7 0 F U N C T I O N
：
F n 0 2 0 - O r i g e t
：
F n 0 2 1 M o t o r I n i t
：
F n 0 0 o f t R e e t
：
F n 0 8 0 P o l e D e t e c t