Buttons / Led Header - Seco SBC Series User Manual

3.3.8

Buttons / LED header

Buttons / LED Header - CN18
Pin Signal Pin
1 HD_LED_P
3 HD_LED_N
5 RST_SW_N
7 RST_SW_P
9 ---
connections: two standard audio jacks, two pushbuttons (for reset and power on) and two LEDs, for SATA activity and Power status signaling.
This adapter module is also contained inside the dedicated cable kit (CABKITA80) for SBC-A80-eNUC board. Please also check chapter 5.2.1for further details.
Signals Description
HD_LED_P: Hard Disk Activity LED signal's pull-up to +5V_S voltage (510Ω pull-up).
HD_LED_N: Hard Disk Activity LED output signal
RST_SW_N: Reset Button GND
RST_SW_P: Reset button input signal. This signal has to be connected to an external momentary pushbutton (contacts normally open). When the pushbutton is
pressed, the pulse of Reset signal will cause the reset of the board. +3.3V_A electrical level with 10kΩ pull-up.
PWR_SW_P: Power button input signal, +3.3V_A electrical level with 10kΩ pull-up. This signal has to be connected to an external momentary pushbutton
(contacts normally open). Upon the pressure of this pushbutton, the pulse of this signal will let the switched voltage rails turn on or off.
PWR_SW_N: Power button GND
FP PWR_P/SLP_N: Power/Sleep messaging LED terminal 1 with 510Ω pull-up resistor to +5V_A voltage. Connect it to an extremity of a dual-color power LED for
power ON/OF, sleep and message waiting signaling. Please refer to Intel
signal meaning.
FP PWR_N/SLP_P: Power/Sleep messaging LED terminal 2 with 510Ω pull-up resistor to +5V_A voltage. Connect it to the other extremity of the dual-color power
LED above mentioned.
SBC-A80-eNUC
SBC-A80-eNUC User Manual - Rev. First Edition: 1.0 - Last Edition: 1.2 - Author: S.B. - Reviewed by G.G Copyright © 2017 SECO S.r.l.
To allow the integration of a SBC-A80-eNUC based system inside a box PC-like, there is a
connector on the board that allows to remote signals for the Power Button (to be used to put
the system in a Soft Off State, or awake from it), for the Reset Button, and the signal for
Signal
optional LED signaling activity on SATA Channel and Power On states.
2 FP PWR_P/SLP_N
The pinout of this connector complies with Intel
4 FP PWR_N/SLP_P
Design Guide, Switch/LED Front Panel section, chapter 2.2. It is shown in the
table on the left.
6 PWR_SW_P
Connector CN18 is an internal 9-pin standard male pin header, p 2.54 mm, 5+4 pin, h=
8 PWR_SW_N
6mm, type NELTRON p/n 2213S-10G-E10 or equivalent.
It is possible to buy SECO's dedicated front panel module, which offers standard
® Front Panel I/O connectivity Design Guide, chapter 2.2.4, for LED functionalities and
®
Front Panel I/O connectivity
31