Legacy Submenu - Seco SBC Series User Manual

USB Boot Enabled / Disabled
EFI device first
EFI/Legacy Device Order Legacy device first
Smart Mode
Enabled / Disabled
UEFI OS Fast Boot
USB Hot Key Support Enabled / Disabled
Timeout 0 ÷ 10
Automatic Failover Enabled / Disabled
EFI See Submenu
Legacy See Submenu

4.6.1 Legacy submenu

Menu Item Options
Boot Menu Normal / Advance
Floppy Drive / Hard Disk Drive
Boot Type Order CD/DVD-ROM Drive / USB /
Other
List of HD Drives found
Hard Disk Drive
connected
List of USB Disks found
USB
connected
SBC-A80-eNUC
SBC-A80-eNUC User Manual - Rev. First Edition: 1.0 - Last Edition: 1.2 - Author: S.B. - Reviewed by G.G Copyright © 2017 SECO S.r.l.
Disables or enables booting from USB boot devices.
This submenu is available only when "Boot Type" is set to Dual Boot Type.
Determine if boot must happen first through EFI devices or through legacy devices, or in Smart Mode.
This submenu is available only when "Boot Type" is set to UEFI Boot Type.
If enabled, the system firmware does not initialize keyboard and check for firmware menu key.
Available only when "Boot Type" is set to UEFI Boot Type and "UEFI OS Fast Boot" is Enabled.
Enable or disable the support for USB HotKeys while booting. This will decrease the time needed to boot
the system
The number of seconds that the firmware will wait before booting the original default boot selection.
When this item is enabled, if boot from the default device fails, then the system will attempt directly to boot
from the next device on the Boot devices list
When this item is disabled, in case of failure from booting from the first boot device, then a Warning
Message will pop up and subsequently enter into Firmware UI.
This submenu is available only when "Boot Type" is not set to "Legacy Boot type".
The submenu will show a list of EFI boot devices. Use F5 and F6 key to change order for boot priority.
This submenu is available only when "Boot Type" is not set to "UEFI Boot type".
Allows setting of Legacy Boot Order
Description
When set to Normal, this submenu will allow configuring all possible options for Legacy boot. When set to
Advance, it will be possible to configure Boot Order only for bootable devices found in the system
This voice will be selectable only when "Boot menu" is set to "Normal".
The list shown under this item will allows selecting the boot from different devices. Use the + and - Keys to
change the boot order priority
This voice will be selectable only when "Boot menu" is set to "Normal".
The list shown under this item will show different Disk drives found connected to the module, therefore
changing the boot priority for them. Use the + and - Keys to change the boot order priority
This voice will be selectable only when "Boot menu" is set to "Normal".
The list shown under this item will show different USB disks found connected to the module, therefore
changing the boot priority for them. Use the + and - Keys to change the boot order priority
57