Table of Contents
Advertisement
SECOCQ7-mITX2.0
User Manual - Rev. First Edition: 1.0 - Last Edition: 1.0 - Author: S.B. - Reviewed by G.M.
Fan Voltage, V_FAN, can be regulated using jumper JP12, which is a standard pin header,
P2.54mm, 1x3 pin.
JP12 position
V_FAN Voltage
1-2
+12V_S
2-3
+5V_S
3.3.21 Front Header Interface
To allow the integration of a SECOCQ7-mITX2.0 based system inside a box PC-like, there is a
connector on the Carrier Board that allows to remote signals for the Power Button (to be used to
put the system in a Soft Off State, or awake from it), for the Reset Button, and the signal for an
optional LED signalling activity on SATA Channel.
Please be aware that PWRBTN# signal and RSTBTN# signal are also managed directly on the
carrier board by the two pushbuttons M2 and M1 (respectively), so it is not mandatory to connect
them externally using CN29.
Connector CN 29 is an internal 9-pin standard male pin header, p 2.54 mm, 5+4 pin, h= 6mm.
Front Header interface – CN29
Pin
Signal
1
+5V_S
3
SATA_ACT#
5
GND
7
RSTBTN#
9
---
3.3.22 MFG Connector
®
According to Qseven
manufacturing and debugging purposes (MFG_NC0÷MFG_NC4).
These pins are carried out directly on connector CN2, which is an IDC connector, dual row, 14 pin,
p2.54 mm connector, type MATSUYAMA LN214 or equivalent.
Please notice that these signals are reserved to the manufacturer of the Qseven
it is not recommended to use them.
MFG Connector – CN2
Pin
Signal
1
UART1_TX
3
---
5
GND
7
MFG_NC3
9
JTAG_TDI
11
GND
13
GND
Please notice that on this connector are reported both JTAG signals and UART signals.
This has been done since, according to Qseven
both JTAG and Debug UART interfaces can be available. Since Debug UART comes out at TTL
electrical level from the module, while most common use of UARTs require that they are at RS-232
level, on the carrier board has been implemented a switching mechanism of MFG_NC1 and
MFG_NC2 signals, driven by jumpers JP8 and JP9.
Pin
Signal
2
+5V_S
4
+5V_A
6
PWRBTN#
8
GND
specifications, on MXM connector there are some pins that are reserved for
Pin
Signal
2
UART1_RX
4
MFG_NC4
6
RSVD (MXM pin 54)
8
MFG_NC0
10
JTAG_TDO
12
MFG_NC1
14
RSVD
Copyright © 2013 SECO S.r.l.
SECOCQ7-mITX2.0
®
specifications, on MFG_NC1 and MFG_NC2
Page 37
®
CPU module, so
Advertisement
Table of Contents
