Power Menu - Seco SBC Series User Manual

4.5 Power menu

Menu Item Options
Advanced CPU Control See submenu
EC Watchdog Configuration See submenu
Thermal Zone configuration See submenu
Always ON
Power Fail Resume Type
Always OFF
WiFi on M.2 Enabled / Disabled
Bluetooth on M.2 Enabled / Disabled
Instant OFF Enabled / Disabled
Enabled
Infrared Support Wake Only
Disabled
Wake on PME Enabled / Disabled
Disabled
By Every Day
Wake on RTC from S5 By Day of Month
By Sleep Time
By OS Utility
Wake from S5 time [hh:mm:ss]
Day of month 1 ÷ 31
Wake from S5 after (seconds) 5 ÷ 44
SBC-A80-eNUC
SBC-A80-eNUC User Manual - Rev. First Edition: 1.0 - Last Edition: 1.2 - Author: S.B. - Reviewed by G.G Copyright © 2017 SECO S.r.l.
Description
These items control various CPU parameters
Embedded Controller Watchdog Configuration Settings
Thermal Zone Configuration: Active and Passive Cooling Settings.
Determine the System Behavior after a power failure event.
In case the option is "Always ON", the board will start every time the power supply is present.
When the option is "Always OFF", the board will not start automatically when the power supply returns.
A CMOS Battery is required to support this feature, otherwise the chipset default setting is Always ON.
Enables or disables the WiFi capabilities of WiFi cards plugged into M.2 slot CN16
Enables or disables the BT capabilities of BlueTooth cards plugged into M.2 slot CN16
In non-ACPI environments, this item will enable the system shut-down by a power button pressure.
Enables or disables the system power-on and power-off managed by the Infrared Remote Control.
When disabled, the Infrared Receiver will be unconditionally disabled.
When enabled, the Infrared Receiver will be able both to put the system in a low power state (S3/S4/S5,
depending on OS configuration) and wake from it
Determines whether the system must wake up or not when the system power is off and occurs a PCI
Power Management Enable wake-up event (e.g. to enable Wake on LAN feature).
Auto wake up from S5 state, it can be set to happen "By Every Day", "By Day of Month", "By Sleep Time" or
"By OS Utility".
Available only when " Wake on RTC from S5" is set to "By Every Day" of "By Day of Month".
Set time of the day when the board must wake up automatically
This menu item is available only when "Auto Wake on S5" is set to "By Day of Month"
This is the help for the day field. Valid range is from 1 to 31. Error checking will be done against
month/day/year combinations that are not supported. Use + / - to Increase / reduce
This menu item is available only when "Auto Wake on S5" is set to "By Sleep Time"
Set the number of seconds after which the board will wake up automatically
53