SECO S.r.l. reserves the right to change precise specifications without prior notice to supply the best product possible. For further information on this module or other SECO products, but also to get the required assistance for any and possible issues, please contact us using the dedicated web form available at http://www.seco.com (registration required).
Check carefully that all cables are correctly connected and that they are not damaged. 1.5 Electrostatic discharges The SBC-A62-J board, like any other electronic product, is an electrostatic sensitive device: high voltages caused by static electricity could damage some or all the devices and/or components on-board.
2.2 Technical specifications Processors Networking ® NXP i.MX6 Family, based on ARM CORTEX-A9 processors Gigabit Ethernet connector i.MX6S Solo - Single core up to 1GHz i.MX6DL Dual Lite - Dual core up to 1GHz per core 2 x standard USB 2.0 Type A i.MX6DP Dual Plus - Dual core up to 1GHz per core Internal USB 2.0 connector i.MX6Q Quad - Quad core up to 1GHz per core...
2.3.1 RTC Battery The SBC-A62-J board can be equipped with an optional low-power Real Time Clock embedded on the module (which is a NXP PCF2123). In this case, the board also mounts a soldered horizontal 3V coin cell lithium battery to supply such a RTC.
Page 20
3.1 Introduction On SBC-A62-J board, there are several connectors located on the upper plane. Standard connectors are placed on the same side of PCB, so that it is possible to place them on a panel of an eventual enclosure. Please be aware that, depending on the configuration purchased, the appearance of the board could be slightly different from the following pictures.
3.3.1 LVDS + backlight connector SBC-A62-J board can be interfaced to LCD displays using its LVDS interface, which allows the connection of displays with a colour depth of 18 or 24 bit, single or dual channel. Optional LVDS connector - CN13 It is possible to configure LVDS output so that it can be used as: ...
USB ports The i.MX6 family of processors offer a native USB 2.0 Host port and a USB 2.0 OTG interface. Depending on the factory option purchased, the SBC-A62-J board can be equipped with a SMSC USB2514 USB 2.0 Hi-Speed Hub Controller, so that the total amount of USB 2.0 Host ports can be four instead of the native one only.
The i.MX6 processor includes two Flexible Controller Area Network (FlexCAN). For this reason, as a factory option, on the SBC-A62-J board it is possible to have a CAN transceiver, for the direct connection of the board to a CAN Bus network.
Due to the various pin multiplexing possibilities offered by i.MX6 processor, in the following table are shown the features supported by SECO’s BSP. It is also shown the i.MX6 pad name connected to each pin of connector J8, for the users who want to explore different configurations not directly managed by the BSP provided.
SECO can provide the customer with SBC-A62-J specific passive heatsinks, which can be useful during the phase of development, in a laboratory, in free - air conditions or just for software development and system tuning.
Page 37
4.2.2 WiFi Modules As stated in paragraph 3.3.6, on the SBC-A62-J there is an internal USB port, on a 6- or 7-pin female header, which has been purposely designed for the connection of USB WiFi modules, although it can be used for any USB 2.0 compliant device.