Priming - Taylor C706 Original Operating Instructions

Step 8
When a steady stream of sanitizing solution is flowing
from the prime plug opening in the bottom of the
freezer door, pull the draw handle down. Draw off all of
the sanitizing solution.
Figure 36
Step 9
Once the sanitizer stops flowing from the door spout,
raise the draw handle. Press the WASH and PUMP
keys, cancelling the beater motor and pump operation.
Figure 37
Note: Be sure your hands are clean and sanitized
before continuing these instructions.
Model C706
Step 10
Lubricate the mix feed tube o--rings located on the end
of the tube with the small hole on the side. Stand the
mix feed tube in the corner of the mix hopper. Place the
locking clip in position on the outlet fitting of the pump.

Priming

Step 1
Place an empty pail beneath the door spout and lower
the draw handle. Be sure the prime plug is still in the
UP position. Pour two gallons (7.6 liters) of fresh mix
into the hopper and allow it to flow into the freezing
cylinder. This will force out any remaining sanitizing
solution. When full strength mix is flowing from the
door spout, raise the draw handle.
Note: Use only FRESH mix when priming the
freezer.
23
Figure 38
050126
Operating Procedures