Taylor C706 Original Operating Instructions page 36

PROBLEM
11. Product is not feeding into
the freezing cylinder.
12. The air/mix pump will not
operate when the PUMP
key is pressed.
13. The air/mix pump will not
operate when the draw
valve is opened and the
unit is in the AUTO mode.
14. The piston travels back
and forth, but product is
not being pumped.
Troubleshooting Guide
PROBABLE CAUSE
a. Inadequate level of mix in
the mix hopper.
b. The mix inlet hole is
frozen up.
a. The circuit breaker is off.
b. The power cord is
unplugged.
c. The freezer is out on
reset.
d. The pump motor is out on
reset.
a. The pump motor is out on
reset.
b. The relay is
malfunctioning.
a. Inspect the pump valve
gasket.
b. Inspect the o--rings.
c. Check the pump cylinder.
32
REMEDY
a. Fill the mix hopper with
mix.
b. The mix hopper
temperature needs
adjustment. Call service
technician.
a. Check the breaker.
b. Plug in the power cord.
c. Reset the freezer.
d. Press the PUMP key to
cancel pump operation.
Press the reset button on
the side of the pump
motor reducer. Press the
PUMP key to continue
pump operation.
a. Press the AUTO key to
cancel the pump
operation. Press the reset
button on the side of the
pump motor reducer.
Press the AUTO key to
continue automatic
operation.
b. Contact service
technician.
a. The pump valve gasket
must be installed correctly,
fit tightly, and not have
any holes or lubrication.
b. O--rings must not be worn,
torn, or fit too loosely.
c. The piston must be
assembled correctly and
fit snugly in the pump
cylinder.
PAGE
REF.
24
------
------
------
13
------
------
------
------
28
19
Model C706