Taylor C706 Original Operating Instructions page 35

PROBLEM
5. The mix in the mix hopper
is too warm.
6. The drive shaft is stuck in
the drive coupling.
7. The freezing cylinder walls
are scored.
8. Excessive mix leakage
into the rear drip pan.
9. Excessive mix leakage
from door spout.
10. No freezer operation after
pressing the AUTO key.
Model C706
PROBABLE CAUSE
a. The temperature is out of
adjustment.
b. The mix hopper cover is
not in position.
c. The MIX REF light is not
lit.
a. Rounded corners of drive
shaft, coupling, or both.
b. Mix and lubricant collected
in the drive coupling.
a. The beater assembly is
bent.
b. The front bearing is
missing or worn on the
freezer door.
a. Missing or worn drive
shaft seal on drive shaft.
b. The rear shell bearing is
worn.
a. Missing or worn draw
valve o--rings.
b. Inadequate lubrication of
draw valve o--rings.
c. Wrong type of lubricant is
being used (example:
petroleum base lubricant).
a. Unit is unplugged.
b. The circuit breaker is off
or the fuse is blown.
c. The beater motor is out on
reset.
31
REMEDY
a. Call service technician to
adjust the mix hopper
temperature.
b. Place the cover in
position.
c. Press the MIX REF key.
a. Call service technician to
correct cause, and to
replace the necessary
components. Do not
lubricate the hex end of
the drive shaft.
b. Brush clean the rear shell
bearing area regularly.
a. Call service technician to
repair or replace the
beater and to correct the
cause of insufficient mix in
the freezing cylinder.
b. Install or replace the front
bearing.
a. Install or replace regularly.
b. Call service technician to
replace rear shell bearing.
a. Install or replace regularly.
b. Lubricate properly.
c. Use the proper lubricant
(example: Taylor Lube).
a. Plug into wall receptacle.
b. Turn the breaker on, or
replace the fuse.
c. Reset the freezer.
Troubleshooting Guide
PAGE
REF.
------
24
12
------
26
------
16
15 / 34
------
17 / 34
17
15
------
------
13