Operation; Generator Set Install And Remove - Pin Type With Locking Bracket; Installation; Figure 3.1 Generator Set Mounting - Pin Type With Locking Bracket - Carrier RG2059 Series Operation And Service

3.1

GENERATOR SET INSTALL AND REMOVE - PIN TYPE WITH LOCKING BRACKET

Figure 3.1 Generator Set Mounting - Pin Type with Locking Bracket

1
A
A
To prevent injury, the procedures provided for installation and removal of the generator set
must be followed carefully.
This generator set is equipped with special pins and mounting bolts and can be installed only
on containers with matching installation points.
3.1.1

Installation

1. Place forks into fork pockets of generator set. Attach safety chain (A) between fork pockets on generator set
and fork truck. Be sure chain (A) is short enough to retain the generator set on the forks.
2. Line up generator set with refrigeration unit and container. Raise generator set until the top is several inches
above the top edge of the container. Move generator set against container and lower into position. Ensure
the two pins (B) are fully engaged in mating holes in container.
3. Keep forks in pockets on generator set and tighten mounting bolt (C) on each side of generator set into con-
tainer frame. Torque mounting bolts to 125 + 25 ft. lbs (17.3 + 3.5 mkg). Ensure locking brackets (D) are
locked into position so as to capture bolt heads (C) and prevent turning.
4. Remove safety chain (A) before removing forks.
SECTION 3

OPERATION

2
B
3
D
C
C
G D
WARNING
!
3–1
4 A
62- 02899- 04 Rev D
T-361