Removal; Generator Set Install And Remove - Clamp Type With Locking Bracket; Figure 3.2 Generator Set Mounting - Clamp Type With Locking Bracket - Carrier RG2059 Series Operation And Service

3.1.2

Removal

1. Move forks into fork pockets on generator set. Attach safety chain (A) between fork pockets on generator set
and fork truck.
2. Release locking brackets (D) on each side of generator set.
3. Remove mounting bolt (C) on each side of generator set and tighten into threaded hole (E).
4. Raise generator set several inches to disengage pins (B) from mating holes and remove from container.
3.2

GENERATOR SET INSTALL AND REMOVE - CLAMP TYPE WITH LOCKING BRACKET

Figure 3.2 Generator Set Mounting - Clamp Type with Locking Bracket

1
D
B
C
D
B
C
To prevent injury, the procedures provided for installation and removal of the generator set
must be followed carefully.
This generator set is equipped with clamps and mounting bolts and can be installed only on
containers with matching installation points for the mounting bolts.
T-361
WARNING
!
Disconnect power plug before removing generator set.
A
A
WARNING
!
2
B
C
D
3
F
E
G
3–2
E
F
62-02899-05 REV E