Figure 5.14 Snubber Hardware - Carrier RG2059 Series Operation And Service

When a shockmount has been cut, split, abraded or has flared due to normal deterioration, it must be replaced.
Damage to the mounts may not be visible when installed and under load from the component. To correctly inspect
shockmounts, they must be removed.
Engine Shockmount Replacement
1. Use the two lift eyes to lift and support the engine.
2. Remove snubber hardware as shown in
3. Remove all hardware as shown in
4. Raise the engine just enough to remove the shockmounts.
5. Inspect shockmounts and replace if required.
6. Lower the engine enough to assemble hardware as shown and torque per
7. Replace snubber hardware as shown in
8. Remove chains from the lift eyes.
Generator Shockmount Replacement
1. Use the two lift eyes to lift and support the engine.
2. Remove snubber hardware as shown in
3. Remove shockmount hardware,
4. Raise the generator just enough to remove the shockmounts.
5. Inspect and if required, install new shockmounts.
6. Lower the engine enough to assemble hardware as shown and torque. Refer to
7. Replace snubber hardware as shown in
8. Remove chains from the lift eyes.
Hexhead Screw
(1/2-13 x 3.50)
T-361
Refer to Section 5.8
Figure
Figure 5.15.
Figure
Figure
Figure 5.16.
Figure

Figure 5.14 Snubber Hardware

Washer (1/2)
Washer, Special
NOTE
for torque values.
5.14.
5.14.
5.14.
5.14.
Bracket Assembly
Lock-nut (1/2-3)
Snubber Washer, Flat
5–14
Section 5.8.
Figure 5.8 for torque values.