Connecting the Printer
The TM-P60II has dual interfaces: a built-in USB interface and another interface selected by the customer, wireless LAN or
Bluetooth interface. See the corresponding section for the interface you selected.
Wi-Fi models:
"USB Interface" on page 42
Bluetooth models:
"USB Interface" on page 42
Before connecting the printer, confirm the current interface mode. The printer is initially set to
Automatic selection:
USB Interface
When communicating with a host PC via the USB cable, connect the USB cable to the printer, turn on the PC,
and then turn on the printer. For Windows, you can change the printer settings with the TM-P60II Utility. For
details on the TM-P60II Utility, see
Putting the USB cable through the wire saddle prevents the cable from coming unplugged.
Do not place any weight or stress on the cable when using. Doing so could damage the cable
When communicating with a host PC via the USB interface, connect the USB cable to the
1
Attach the enclosed wire saddle to the printer as shown in the illustration below.
2
Put the USB cable through the wire saddle.
Wire saddle
42
or
"Wireless LAN Interface" on page 43
or
the Automatic selection mode. To change the interface mode, see
48.
When the USB cable is connected with a host PC, the USB interface is preferentially selected.
However, if the printer is turned on before turning on a host PC, the wireless LAN/Bluetooth
interface is selected. When the USB cable is not connected with a host PC, the wireless LAN/
Bluetooth interface is selected.
"Software Settings" on page
and connectors.
printer before turning on the printer.
"Bluetooth Interface" on page 44
48.
"Software Settings" on page