Epson TM-P60II Technical Reference Manual page 62

SimpleAP mode (SimpleAP)
In Wi-Fi model, select 2: SimpleAP to start in SimpleAP mode (the same as the factory default setting).
Select this to use Quick connection for Wi-Fi model.
For information on the Quick connection function, see
27.
Auto re-connect to iOS device (Bluetooth)
In Bluetooth model, select 2: Bluetooth and set in 1: Auto Re-Connect iOS, you can select whether to enable or
disable auto reconnection to iOS devices. (iOS Bluetooth model only)
For information on the Auto re-connect feature, see
on page
When the firmware version is 6.12 ESC/POS or later:
1
After selecting the setting value, press the Feed button again.
(Keep pressing the button until the printer starts printing.)
The selected setting value (Enable/Disable) is printed.
2
The printer starts printing Wireless Module Setup instructions.
Changing the settings is complete. You can turn off the printer.
When the firmware version is 6.11 ESC/POS or earlier:
1
After selecting the setting value, press the Feed button again.
(Keep pressing the button until the following message is printed.)
"Please release the Feed button."
2
The printer restarts.
iAP2 Protocol Settings (Bluetooth)
When the firmware version is 6.14 ESC/POS or later, you can change the accessory protocol (iAP2) settings
used to connect with the device. (iOS Bluetooth model only)
In iOS Bluetooth model, select 2: Bluetooth, and then select 2: iAP2, and you can change the settings.
Setting
Enable (default)
Disable
62
104.
iAP2 is used to connect to the device. This setting should normally be used.
iAP1 is used to connect to the device. Use when there is a problem connecting to the
device using iAP2.
"Useful Functions for Smart Devices" on page
"Auto Reconnect Feature (iOS Bluetooth model)"
Explanation