Bluetooth Interface - Epson TM-P60II Technical Reference Manual

Setting up from a Windows Computer
1
Connect the printer to a PC via the USB cable.
See "USB Interface" on page
2
Turn on the printer.
3
Start up EpsonNet Config.
4
Double-click on the printer.
5
Configure the [Network] settings and the [TCP/IP] settings.
6
Disconnect the USB cable, turn off the printer, and then turn it back on.
Be sure to disconnect the USB cable, turn off the printer, and then turn it back on after using
EpsonNet Config via the USB interface.
If you need to configure other settings, use EpsonNet Config (web version). For information about
EpsonNet Config (web version), see

Bluetooth Interface

Use a tool, such as a built-in Bluetooth connection tool of your device to establish the connection with the
printer. If your device is a Windows computer, use EPSON TM Bluetooth
pair a terminal and the printer.
 If the host computer and the printer are not connected on a continuous basis but rather con-
 If data transfer from an application of the host computer has already been completed, data
44
42.
nected every time the printer starts printing, some time may be needed for the printer to actu-
ally start printing after the host computer commands printing. This pause is the time required
for processing the connection between the host computer and the printer, and it depends on
the conditions of the environment where used.
might remain in the Bluetooth module internal buffer. As such data remaining in the buffer
might be lost when the connection is cut off, use the status or similar functions to check that
transmitted data has been completely printed before cutting off the wireless connection.
"EpsonNet Config (Web Version)" on page
®
Connector, which is a utility to easily
68.