Hexadecimal dumping mode
In hexadecimal dumping mode, data from the host computer is printed in hexadecimal numbers and charac-
ters. By comparing the print outs and the program, you can check whether or not data is being sent to the
printer correctly.
The hexadecimal dumping mode can only be executed in the label continuous issuing mode. If
executed in the label peeler issuing mode, a paper layout error occurs when paper is detected by
the label peeler sensor.
When there are no characters that correspond to the print data, " . " is printed.
If you press the FEED button when there is less than one line of print data, one line is printed.
During hexadecimal dumping mode, applications that check the printer status may not operate
correctly. The printer only returns the status for the "Real-time transmission status" command.
Follow the steps below.
1
Open the roll paper cover.
2
While pressing the FEED button, turn on the printer. (Hold down the FEED button
until the Error LED turns on.)
3
Close the roll paper cover.
From this point, all data received by the printer is printed in the corresponding hexadecimal num-
bers and ASCII characters.
Example of printing in hexadecimal dumping mode
4
To close hexadecimal dumping mode, turn off the printer after printing is complete,
or press the FEED button for three times.
Chapter 3 Advanced Usage
65
3