Software Settings Mode - Epson TM-P60II Technical Reference Manual

Software settings mode

Set the printer's memory switch (customized value).
 Print density
 Automatic paper reduction
 Interface selection
 USB communications settings
 Print speed
 NV memory capacity
The software setting mode can only be executed in the label continuous issuing mode. If it is executed
in the label peeler issuing mode, a paper layout error occurs when paper is detected by the label
peeler sensor.
For details on the memory switch (customized value), see
Follow the steps below.
1
After running a self test, hold down the FEED button for at least one second, and then
select the Mode selection.
The Mode selection guidance is printed, and the
2
Briefly press the FEED button twice (less than one second), hold it down for at least
one second, and then select the Software settings mode (Customized value setting).
The Software setting mode guidance is printed, and the
58
 Command execution during offline
 Transmission of status notice
 Buzzer control
 Automatic power off setting
 Paper position immediately after specific state
"Software Settings" on page
Power LED flashes.
Power LED flashes.
48.