Transmission of Status notice
Transmits (initial setting)
Does not transmit
Buzzer settings
Buzzer sounds for low battery warning: disabled or enabled (initial setting)
Buzzer sounds for roll paper end warning: disabled or enabled (initial setting)
Buzzer sounds for error occurrence warning: disabled or enabled (initial setting)
Paper position immediately after the specific state
Not specified as "Start of printing" (initial setting)
Specified as "Start of printing"
To enable this function, select the memory switch 8-7 with the customized value "Allocation of
paper position immediately after the memory switch specific state. "
USB class
Printer Class
Vendor Class (initial setting)
Bluetooth interface
Passkey (initial setting: 0000)
Device name (initial setting: TM-P60II_xxxxxx)
Security (initial setting: Low)
Auto Re-Connect with iOS device (initial setting: Enabled)
The device name is initially set to TM-P60II_xxxxxx.
(xxxxxx refers to the last 6 digits of the serial number labeled on the back of your printer.)
When the firmware version is 6.14 ESC/POS or later, you can change the Bluetooth security
settings. (iOS Bluetooth model only)
Chapter 3 Advanced Usage
53
3