Decoding Operation; Configuring Decoded Video Display - HIKVISION DS-6500DI–T User Manual

User Manual of DS-6500DI–T Universal Network Decoder

4.1 Decoding Operation

4.1.1 Configuring Decoded Video Display

Purpose:
To realize the display of the decoded video on the TV wall, you must set the decoding operation parameters.
Before you start:
Check the cabling of the decoder, and ensure that the decoder is connected to the TV wall or monitor via the
video output interfaces.
To set the video output of the decoder, the first step is to choose the video output interfaces. There are 2 types of
video output interfaces, the BNC and DVI outputs.
Steps:
Click Decode Operation > Decode Mode > Display Control to enter the display control interface:
1.
In the display control interface, you can configure the Display Channel, Video Format (BNC), BNC Output
2.
Scaling (BNC), Output Resolution (DVI) and Display Mode.
Select the window-division display mode. The DS-6500DI-T series supports 1/4/6/8/9/12/16-division
3.
display mode.
Select the decoding channel from the drop-down list for each sub-window.
4.
Click Save to save the settings and the prompt
5.
After having configured the window-division display, the sub-window information can be viewed on the
interface.
Example: If you select the display mode as 4, the sub-window configuration field shows the status of the four
sub-windows.
Figure 4.3 Display Configure
Figure 4.4 Configure Display Parameters
16
pops out.