Decoding Operation - HIKVISION DS-6300DI-JX Series User Manual

User Manual of DS-6300DI-JX Decoder

5.1 Decoding Operation

Purpose:
To realize the display of the decoded video on the TV wall, you must set the decoding operation parameters.
Before you start:
Check the cabling of the decoder, and ensure that the decoder is connected to the TV wall or monitor via the video
output interfaces.
To set the video output of the decoder, the first step is to choose the video output interfaces. VGA and BNC outputs
are provided.
Steps:
1. Click Decode OperationDisplay Configure to enter the display configuration interface:
2. You can select VGA or BNC display mode for configuration.
Note: The HDMI and DVI are not supported by DS-6300.
3. Select the display channel, video standard (PAL/NTSC), output resolution (for VGA output), BNC slim (for
BNC output) and the screen mode.
Note: Make sure the screen mode you select is supported by the current video output interface of the device.
E.g., the VGA1 of DS-6308DI supports 1/2/4/9/16-division display mode, while other video output interfaces
of it support 1/2/4-division display mode.
4. Click Save to save the settings and the prompt
5. After the screen mode has been selected, the sub screen information can be viewed in the interface, shown as
below:
will be displayed.
31