Market Forge Industries ECO-TECH PLUS ETP-10E Installation & Operation Manual page 7

INSTALLATION, OPERATION MANUAL, MODEL ETP-10E
3.0 INSTALLATION (Continued)
TO INSTALL:
1. Uncrate carefully. Report any freight damage to the freight company immediately.
2. Set the unit in place.
3. Using a spirit level or pan of water in the bottom of the steamer, adjust the levelling feet to
level the steamer front-to-back and side to side.
4. Mark hole locations on the floor through the anchoring holes provided in the flanged
adjustable feet. Remove the steamer and drill holes at marked locations on the floor. Insert
proper anchoring devices.
5. Set steamer back in proper position.
6. Install bolts through anchoring holes and into anchors to secure the steamer to the floor.
Seal bolts and flanged feet with Silastic™ or equivalent.
7. After the drain is connected, check for level by pouring water onto the floor of the compartment.
All water should drain through the opening at the back of the compartment cavity.
WARNING: Disconnect the power supply to the appliance before
cleaning or servicing.
Make electrical connection through 1-1/8" (29 mm) diameter hole provided using 3/4" (19 mm)
trade size conduit. Refer to the wiring diagram located inside the right side panel. Use 90 C
minimum insulated wire.
Part No. 10309R0 7 2019-05-14