Market Forge Industries ECO-TECH PLUS ETP-10E Installation & Operation Manual page 15

INSTALLATION, OPERATION MANUAL, MODEL ETP-10E
5.0 OPERATION INSTRUCTIONS (Continued)
ADJUSTMENT FOR HIGH ALTITUDE LOCATIONS
The steamer has been factory set so that when it is ON, and during the READY phase, it will
maintain water temperature in the steam generator tank at approximately 200 F (93 C) (just
below water boiling point). However, for high altitude locations, an authorized service agency
must adjust the steamer to achieve this temperature.
WARNING: The steamer and its parts are hot. Use care when
operating, cleaning or servicing the steamer. The cooking
compartment contains live steam. Stay clear when opening door.
CAUTION: An obstructed drain can cause personal injury or
property damage.
Part No. 10309R0
CONTROLS
1. Ready Pilot Light
2. Cooking Pilot Light
3. Timed Cook/Hold Mode
4. Main Power Switch
ON
OFF
DELIME
5. Temperature Display
6. Buzzer
When lit, indicates steam generator has reached
200º F (93º C) and is ready for the cooking cycle.
When lit, indicates that a cooking cycle is in
progress.
Set the cooking time (0 to 60 minutes) - steam
cooking will begin after the door is closed. The
cooking cycle will be interrupted if the door is opened
during the cooking cycle; resume cooking by closing
the door. Hold - For keeping cooked foods warm
after cooking, at or above 150 F (65 C).
The steam generator will automatically fill and
begin heating to the pre-set temperature for
standby. Red light will ignite on the main power
switch.
The steam generator will drain. No lights.
Closes the drain valve while "Total Concept" liquid
is being poured into the steam generator during the
Delime procedure. Amber light will illuminate.
Shows temperature within the cooking cavity.
Signals end of cooking period (not shown).
15 2019-05-14