Market Forge Industries ECO-TECH PLUS ETP-10E Installation & Operation Manual page 22

INSTALLATION, OPERATION MANUAL, MODEL ETP-10E
6.0 PREVENTIVE MAINTENANCE (Continued)
4. Use warm soapy water with a cloth or sponge to clean exposed bead of door gasket, rinse
with warm clear water and wipe with a dry cloth.
Wipe surfaces which touch door gasket with a cloth or sponge and warm soapy
water, rinse with warm clear water and wipe with a dry cloth. Do not apply food oils
or petroleum solvents or lubricants directly to door gasket or surfaces which touch
door gasket.
5. Remove drain screen from inside compartment drain. Using a plastic bottle brush and
mild detergent, clean inside the drain opening ensuring there is no food residue or
blockage. Clean the drain screen and replace in its original position.
6. Leave door slightly open when steamer is not in use.
CAUTION: Do not use cleaning agents that are corrosive.
NOTICE: Contact the factory, the factory representative or a local service
company to perform maintenance and repairs should the appliance
malfunction. Refer to warranty terms.
CLEANING (WEEKLY)
Weekly, or more often if necessary:
1. Clean exterior with a damp cloth and polish with a soft dry cloth.
2. Use a non-abrasive cleaner to remove discolorations.
Following daily and periodic maintenance procedures will enhance long-life for your equipment.
Climatic conditions - salt air - may require more thorough and frequent cleaning otherwise the
life of the equipment could be adversely affected.
It is NOT RECOMMENDED to use cleaning agents that are corrosive.
Part No. 10309R0 22 2019-05-14