Cleaning, Maintenance And Validation; Check & Clean Process - Dentsply Sirona DAC Universal Touch Operating Instructions Manual

5 Cleaning, maintenance and validation

5.1 Check & Clean process
82
5
Cleaning, maintenance and validation
Check & Clean process
5.1
Frequency: Weekly or every 50 cycles (whichever comes first).
After every 50 cycles, the DAC Universal will display the message
04:00 PM
shown at the left. This message reminds the user that the weekly Check
& Clean cleaning/maintenance is due.
The second table below shows how often cleaning/maintenance should
be carried out. The numbers at the far left of the table correspond with
the subsections in this chapter.
The frequencies indicated are based on approx. 10 complete cycles per
day. If the DAC Universal is used more frequently, you should adjust the
Check & Clean intervals accordingly.
WARNING
Risk of contamination!
Please ensure that the Check & Clean process is conducted regularly
at the intervals required in these instructions for use.
The software will take you through the individual Check & Clean steps.
The menu guidance in the Check & Clean process is as follows:
Operating Instructions DAC Universal
Navigate to the next step
Navigate to the previous step
Navigate to the next Check & Clean
chapter
Navigate back to the previous Check
& Clean chapter
Cancel a process
D3708.201.01.01.02 04.2019
Dentsply Sirona
6681006 D3708