Johnson Controls YORK YK Style G OPTIVIEW Operation And Maintenance page 2

READ BEFORE PROCEEDING!
This equipment is a relatively complicated apparatus.
During installation, operation maintenance or service,
individuals may be exposed to certain components or
conditions including, but not limited to: refrigerants,
materials under pressure, rotating components, and
both high and low voltage. Each of these items has the
potential, if misused or handled improperly, to cause
bodily injury or death. It is the obligation and respon-
sibility of operating/service personnel to identify and
recognize these inherent hazards, protect themselves,
and proceed safely in completing their tasks. Failure
to comply with any of these requirements could result
in serious damage to the equipment and the property in
The following symbols are used in this document to alert the reader to specific situations:
Indicates a possible hazardous situation
which will result in death or serious injury
if proper care is not taken.
Indicates a potentially hazardous situa-
tion which will result in possible injuries
or damage to equipment if proper care is
not taken.
External wiring, unless specified as an optional connection in the manufacturer's product line, is
not to be connected inside the OptiView cabinet. Devices such as relays, switches, transducers and
controls and any external wiring must not be installed inside the micro panel. All wiring must be in
accordance with Johnson Controls' published specifications and must be performed only by a qualified
electrician. Johnson Controls will NOT be responsible for damage/problems resulting from improper
connections to the controls or application of improper control signals. Failure to follow this warning
will void the manufacturer's warranty and cause serious damage to property or personal injury.
2
IMPORTANT!
GENERAL SAFETY GUIDELINES
SAFETY SYMBOLS
which it is situated, as well as severe personal injury or
death to themselves and people at the site.
This document is intended for use by owner-authorized
operating/service personnel. It is expected that this in-
dividual posseses independent training that will enable
them to perform their assigned tasks properly and safe-
ly. It is essential that, prior to performing any task on
this equipment, this individual shall have read and un-
derstood this document and any referenced materials.
This individual shall also be familiar with and comply
with all applicable governmental standards and regula-
tions pertaining to the task in question.
Identifies a hazard which could lead to
damage to the machine, damage to other
equipment and/or environmental pollu-
tion if proper care is not taken or instruc-
tions and are not followed.
Highlights additional information useful
to the technician in completing the work
being performed properly.
FORM 160.75-O1 (211)
JOHNSON CONTROLS